Thread: Trees
View Single Post
Old 01-22-2017, 12:33 PM   #23 (permalink)
edwmax
 
Location: Cairo, Ga
Zone: 8b
Join Date: Aug 2016
Posts: 2,891
BananaBucks : 115,417
Feedback: 0 / 0%
Said "Thanks" 1,740 Times
Was Thanked 4,439 Times in 2,094 Posts
Said "Welcome to Bananas" 414 Times
Default Re: Trees

The tree is sitting down on the saw. Cuts like that needs to be followed with a wedge to keep the cut open and saw free. You might be able to use a wedge to free the saws.

To cut down the tree, start on the side & direction you want the tree to fall. Make a short cut horizontal; then drop a few inches below cutting up wards to remove a wedge slice. Repeat enlarging the cut until about 1/3 -1/2 the way in, the tree should start leaning slightly. Stop ... move to the opposite side cut in horizontal or I prefer to cut downward angle to meet the other cut at the center. This cut should be getting wider as the tree leans. if the first cut was deep enough. Use a wedge at first to keep the tree from sitting back on the saw.

I'm not a lumber jack, but I have cut down a couple of large pine trees in the yard.
__________________
edwmax is offline   Reply With Quote Send A Private Message To edwmax